Description
Details
1. Model: XZD-2004-C
2. PCB Material: FR4 (55mm *7.5mm)
3. Overcharge detection voltage(VCU): 4.35±0.05V
4. Overcharge detection delay time: 1.0±0.5mS
5. Over discharge detection voltage: 2.3±0.1V
6. Over discharge detection delay time: 1.0±0.5ms
7. Over current detection voltage: 0.30±0.015V
8. Over current detection current: 7-12 A
9. Detection delay time: 1.0s
10. Release condition: Cut load
11. Detection conditionp: Exterior short circuit
12. Detection delay time: 10ms
13. Release condition: Remove the Load
14. Normal mode: 10uA
This BMS-system can't balance a battery pack, it's only for the cutoff of under and over-voltage
Additional Information
Details
B- = negative (like 0V/ground)
B+ = positive (like +7.4V)
BM = between the 2 celsl (like +3.7V)
P-=charge/power output negative
P+=charge/power output positive
T= for 10k PTC
Datasheet
Reviews
Customer Reviews
- make a pack for my LED bicycle headlight. Review by Yves SOUSSI
-
Rating
1) I'm using this board to make a pack for my LED bicycle headlight. The pack that came with the headlight was crap and the charger was worse so I bought a set of 4 18650 cells, this IC, and a 2x cell holder. Now I can carry an extra set of cells on longer rides and more importantly, I can charge each cell individually and keep them balanced using my XTAR charger. And if I forget to unplug my cheap headlight after a ride, this circuit will keep the cells from dropping too low. (I've already killed 2 unprotected packs like this).
Best regards
YVES SOUSSI
(Posted on 02-04-18)